![]() It is advised to have the headlights adjusted by a dealer service department or service station as soon as possible. It is important to note that it may not be possible to position the headlight aim exactly for both high and low beams, and if a compromise must be made, prioritizing the proper aim of the low beams is recommended for safety. ![]() With the high beams on, the high intensity zone should be vertically centered with the exact center just below the horizontal line. Canadian Tire has all the auto parts you need, from brake pads to car batteries, to battery chargers and wiper blades. Starting with the low beam adjustment, the high intensity zone should be positioned two inches below the horizontal line, and adjustment is made by turning the adjusting screw. Useful information for Chevrolet Cobalt owners who need to replace a bulb in their car and allows them to quickly find the correct bulb type / size for replacement. The vehicle should be parked 25 feet from the wall, sitting level, with the gas tank half-full and no heavy load in the vehicle. The tape is positioned vertically on the wall in reference to the vehicle centerline and the centerlines of both headlights, and a horizontal tape line is positioned in reference to the centerline of all the headlights. Here at Advance Auto Parts, we work with only top reliable Low Beam Headlight Bulb product and part brands so you can shop with complete confidence. When it comes to your Chevrolet Cobalt, you want parts and products from only trusted brands. To adjust the headlights, one method involves using masking tape, a blank wall, and a level floor. The best part is, our Chevrolet Cobalt Low Beam Headlight Bulb products start from as little as 19.29. There are no horizontal adjustment screws. Part 9007XV-47 Check if this fits your 2006 Chevrolet Cobalt Application: Low beam Notes: Headlight Bulb. A: The adjustment procedure for headlights on Cobalt/GS and ION models involves locating the vertical adjustment screws behind each headlight housing, while on HHR models, the vertical adjustment screw is found under the inner fender flange.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |